后面板动态信号分析仪 HP3562A厂家: 美国惠普原值 $22,050美元性能指标pdf1,性能指标pdf2HP3562A动态信号分析仪是一种双通道系统、频谱、波形分析仪。有时域和频域两方面的分析能力，它具有100KHz的频宽，150dB的测量范围和80dB的动态分析范围，因此，在机械、机电一体化控制系统中有着强大的分析解决问题的能力。1.频率测量范围：64μHz～100KHz精度：频率读数误差±0.004%分辨率：跨距/800跨距基（本频）带图象电子放大跨距数6664最小跨距10.24mHz20.48mHz最大跨距100KHz100KHz时间记录800/跨距800/跨距2.相位精度：<10KHz ±2.5010KHz～100KHz ±12.003.动态范围： 所有畸变的和≤低于输入范围最大刻度值的80dB4.输入阻抗： 1MΩ±5％5.工作环境：环境温度：0～55℃ ; 相对湿度：40℃时 ≤95％Hewlett Packard 3562ADual-Channel, Dynamic Signal Analyzer 64 µHz to 100 kHzNetwork, spectrum, waveform, transient analysisLinear, logarithmic, swept sine modes80 dB dynamic range with full alias protectionHigh accuracy (±0.15 dB)Frequency Response MeasurementsWith linear resolution FFT logarithmic resolution and swept sine analysisBuilt-in signal source provides a variety of random noise and sine wave signalsSpectrum AnalysisOn-line analysis of distortion, drift, modulation, and phase noiseWaveform and Transient AnalysisAnalysis of waveforms and transients in the time and frequency domainsArray of triggering capabilities enhances both waveform recording modes.   Pre- and post-trigger delays can be specifiedHardcopy and Mass StorageHP-IBWith direct control of plotters and disk drivesSpecificationsFrequencyMeasurement Range: 64 µHz to 100 kHz.  Both channels, single- or dual-channel operationResolution: span/800SpansBasebandZoom# of spans6664min span10.24 mHz20.48 mHzmax span100 kHz100 kHztime record (sec)800/span800/spanWindow functions: flat top, Hann, uniform, force, exponential, user-definedTypical real-time bandwidths: Single-channel, fast averaging 10 kHzAmplitudeInput Ranges: +27 dBV to -40 dBV; -41 dBV to -51 dBVInputInput Impedance: 1Mohm ±5% shunted by < 100 pFInput Coupling: inputs can be ac or dc coupled - ac rolloff is < 3 dB at 1 HzTriggerTrigger Modes: free run, input channel 1, input channel 2, source and external triggerTrigger Delay: pre- and post-trigger delay resolution is 1 sample (1/2048 of a time record)Pre-trigger: a measurement can be based on data that starts from 1 to 4096 samples (1/2048 to 2 time records) before trigger conditions are metPost-trigger: a measurement is initiated from 1 to 65,536 samples (1/2048 to 32 time records) after the trigger conditions are metSourceRandom noise, burst random, sine chirp, burst chirp, fixed sine, and swept sine are availableOutput Impedance: 50 ohm (nominal)Output Level: between +10 and -10 V peak (ac + dc) into a>10 kohmac level: ±5 V peakdc offset: ±10 V peak in 100 mV steps Network analysisSpectrum analysisTransient analysisWaveform recordingFrequency response analyzerModulation analysisDirect control of disc drivesDirect control of HP-GL plottersThe HP 3562A Dynamic Signal Analyzer is a dual-channel fast Fourier transform-based network, spectrum and waveform analyzer which provides analysis capabilities in both the time and frequency domains.   The dc-to-100 kHz frequency range, 150 dB measurement range and 80 dB dynamic range of the analyzer makes it a powerful solution for testing and analysis in electronics, mechanics and electromechanical control systems.Two high performance input channels and a built-in signal source (noise and sine signals) address network analysis on the bench or in a test system.  Zoom analysis with frequency resolution to 25.6 µHz plus a powerful AM, FM and PM demodulation function makes the HP 3562A a versatile spectrum analyzer.  For transient or waveform analysis, signals can be sampled, digitized then stored in an internal memory, or directed via HP-IB to an external disc drive (without a computer).  The stored waveforms can be recalled and analyzed in the time and frequency domains (baseband and zoom analysis).Additional features include a full range of data analysis capabilities such as vector averaging, block-operation Waveform Math, a 40-pole/40-zero Curve Fitter and Frequency Response Synthesis.  Front panel operations can be automated without a computer with built-in Auto Sequence programming, or with computers through complete HP-IB programmability.  For documentation of results with hardcopy or mass storage, the HP 3562A can control digital plotters and external disc drives directly via HP-IB.Network AnalysisAccurate, high resolution frequency response measurements of electronic and mechanical systems can be performed with Linear Resolution FFT, Logarithmic Resolution and Swept Sine Analysis.  A built-in signal source provides a variety of random noise and sinewave signals to meet the requirements of the system under test.Linear Resolution is the measurement technique common to all Dynamic Signal Analyzers.  In the HP 3562A, 2048-point time records are Fourier-transformed in to 801-line frequency spectra.  For network analysis, frequency response magnitude and phase, as well as input and output power spectra, can be measured with 801 lines of resolution.  Accuracy for the frequency response magnitude and phase is ± 0.1 dB and ± 0.5°.Logarithmic Resolution uses the speed of Linear Resolution FFT measurements to create frequency responses similar to a log-sweep swept sine test.  Linear Resolution points are combined internally (rather than just reformatted), on the fly, to create 80-point-per-decade measurements over 1 to 5 decades.  Start and stop frequencies can be selected in a 1-2-5 sequence from 0.1 Hz to 100 kHz (for a 0.1 Hz start frequency the maximum stop frequency is 10 kHz - 5 decades).The Swept Sine mode reconfigures the HP 3562A as a powerful swept sine frequency response analyzer.  The source can generate linear or logarithmic sweeps with increasing or decreasing frequency; user-selectable sweep rate and resolution are also standard source functions.  Input channel functions include user-selectable averaging and integration time; automatic input ranging can be activated to provided over 130 dB of dynamic range for measurements of high performance systems.Spectrum AnalysisOn-line analysis of distortion, drift, modulation and phase noise can benefit from the speed and accuracy of the HP 3562A.  High resolution measurements are typically 100 times faster than tuned spectrum analyzers - and, since the HP 3562A is an FFT-based analyzer, you can see transient events that a tuned analyzer would probably miss.The HP 3562A is essentially a dual-channel spectrum analyzer which provides resolution to 25.6 µHz anywhere within the dc-to-100 kHz measurement range. Single channel accuracy is ± 0.15 dB with 80 dB of dynamic range.  Modulation analysis can be performed on either or both channels with harmonic and sideband markers as well as with the built-in demodulation capability: zoom measurements can be AM, FM, or PM demodulated with carrier frequencies up to 99.9 kHz.Waveform and Transient AnalysisPerform complete analysis of waveforms and transients in the time and frequency domains.  Sampled and digitized waveforms can be stored in internal memory (signal-channel Time Capture) or on disc in an external disc drive (single- or dual-channel Time Throughput). Data can be recalled for time domain analysis as single time records or as a compressed display of up to 10 time records (Time Capture mode). Data can also be recalled for baseband and zoom analysis in the frequency domain, with vector averaging if needed.A complete array of triggering capabilities are included to enhance both waveform recording modes.  Pre- and post-trigger delays can be specified to capture the rising edge of a transient or to compensate for delays in the system under test.Data Throughput to a Disc DriveWhen access to prototypes is limited, make your test time more efficient with the Time Throughput capability: through direct control of external disc drives, the HP 3562A can store time data directly to disc without a computer. Set up a measurement and specify the quantity of single- or dual-channel data to be collected. Time data will be sampled, digitized and stored on disc for later analysis as individual time records or as baseband and zoom frequency spectra.Hardcopy and Mass Storage with Plotters and Disc DrivesTo speed and simplify documentation of results, direct control of plotters and disc drives via HP-IB is a standard feature in the HP 3562A.  Literally anything displayed on the analyzer screen can be plotted or saved on disc: measurement results, setup state tables, synthesis tables, curve fit tables and Auto Sequence or Auto Math program listings.  Plotting is enhanced with user-selectable line types, pens and paging controls.  For mass storage operations, files can be given 8-letter user-defined names; and disc catalog can be recalled and displayed to show file name, type (data, setup, etc.) and date and time of storage.Automation for Improved ProductivityVersatile automation capabilities and a wide range of response-only or stimulus/response measurement functions in the HP 3562A help you create productive solutions for your automated testing needs.  As a standalone solution, the analyzer can "learn" a series of keystrokes and then perform them on command (Auto Sequence programming).  Up to five Auto Sequence programs can be stored internally, with additional programs stored in an external disc drive.For networked HP-IB systems, the HP 3562A provides complete HP-IB programmability.  Custom display graphics and messages can be created through direct programming of the high resolution vector display - user-defined soft key menus can also be created to simplify interactive testing.  Rear-panel outputs for large screen displays are also standard.电话: 010 - 62123258 / 62123259   邮箱:buy17@163.com型号: HP 3582A厂家: 美国惠普频率范围 0.02 Hz to 25.5 kHzSPAN 1 Hz to 25 kHz (1-2.5-5-10 步进)双通道测量内置信号源详细介绍接口照片型号: HP 3562A厂家: 美国惠普HP3562A动态信号分析仪是一种双通道系统、频谱、波形分析仪。有时域和频域两方面的分析能力，它具有100KHz的频宽，150dB的测量范围和80dB的动态分析范围。频宽范围:64μHz～100KHz详细介绍接口照片型号: HP 3563A厂家: 美国惠普模拟和数字设备信号分析、电路网络分析、电路网络的辅助设计等详细介绍-型号：HP3567A厂家：美国惠普主机 HP35650A插件HP35653C Source ModuleHP35652B Input ModulesHP35651C Processor Module频率范围 64uHz～100kHzSimultaneous samplingExten. data cordinatesStandard Data Format102.4kHz Frequency anal BWVoltage TransducerIEPE TransducerPow/Lin SpectrumFrequency ResponseRMP Spectral MapAuto/Cross Correlation性能指标pdf接口照片名称: 动态信号分析仪型号: HP35660A厂家: 美国惠普第1通道：102.4kHz (488µHz)第2通道：51.2kHz (244µHz)详细介绍接口照片型号: HP 35665A厂家: 美国惠普频率范围： 通道一 102.4kHz 通道二 51.2kHz分辨力： 单通道模式 244μHz 双通道模式 122μHzSPAN： 单通道模式 102.4 kHz - 0.19531 Hz 双通道模式 51.2 kHz - 0.097656 Hz详细介绍名称: 傅立叶频谱分析仪型号:SR760厂家: 美国 SRS476μHz-100KHz，一个通道，可以平衡输入详细介绍 接口照片 名称: 高分辨力信号分析仪(傅立叶分析)型号: 2033厂家: 丹麦 BRUEL & KJAERDC-20KHz详细介绍北京市北方思源电子技术中心 电话：010-62123258  联系人：刘凌